|
国标的托盘高度一般在100mm，所以国标的手动液压搬运车**高度当然在这之下。一般的液压搬运车放到**点的时候高度是85mm、75mm两种，当然也有特殊的低放型手动液压搬运车，**高度甚至能达到35mm。低放车一般价格稍贵，没有特殊需求不建议采购。而且低放到35mm的手动搬运车钢板相对来说比较薄，所以载重最多只有1.5吨。
Lift height
GB tray height is generally at 100mm, so the national standard of manual hydraulic trucks minimum height, of course, under this. The general hydraulic pressure truck to the lowest point, height is 85mm, 75mm two, of course, there are special low release manual hydraulic carrier, the minimum height can even reach 35mm. The price of a low - lift truck is a little expensive, and there is no special requirement. And the manual pallet truck with low 35mm is relatively thin, so the load is only 1.5 tons at most.
三月，醉一场青春的流年。人生的三月，我们正值青春，风华正茂。在这样一个充满活力的年纪，我们要把握机遇，朝人生的**冲刺；我们要珍惜每一个让我们流连忘返的风景，保持年青的心态，随时准备着与时间赛跑；我们要在时光深处，保持一种淡然而洒脱，矜持而深情的微笑，让三月的风景陪我们笑语盈盈，清芬一路。
手动液压车轮子材料要根据作业地面的状况来选择。地面状况平滑的可以选择尼龙轮子，因为尼龙的轮子相对比较便宜，而且拉着也比较省力。地面状况不好的，可以选择铝合金加聚氨酯的轮子，它们比较耐磨。如果不想太伤地面，比如工厂有些是地坪的地面，**不要用尼龙的轮子，应该选用聚氨酯的。因为尼龙的太硬了，聚氨酯相对来说比较软一点。
Wheel material
Manual hydraulic car wheel material according to the situation of the ground to choose. The ground condition is smooth, you can choose nylon wheel, because nylon wheel is relatively cheap, and pulling is also more labor-saving. The ground condition is bad, you can choose aluminum alloy plus polyurethane wheels, they are more wear-resistant. If you do not want to hurt the ground too, such as factories, some ground floor, it is best not to use nylon wheels, polyurethane should be used. Because nylon is too hard, polyurethane is a little softer. |
