无锡五金厂地坪价格是多少 400-0709-910(请拨打400-0709-910电话,永坚地坪公司)
Whether the cement floor or tile floor, we have to be polished, and for the depth of the tile floor must be polished, tiled floor because the material itself is relatively compact, not easily penetrate and bonding, only the fine sanding rough ground, in order to enhance floor paint and bonding effect the ground. And with respect to the requirements of flatness to the ground to have to wear a floor tile spacing gap must be addressed. This off relatively time consuming, but is a very important part.
2. The epoxy floor paint primer construction
Because epoxy floor paint primer play a connecting role in floor paint coatings, the construction must be adequate, even to enhance the wear-resistant flooring epoxy primer strength and abrasion resistance, in order to avoid from the shell, delamination and other phenomena.
3. epoxy floor paint mortar layer must be thicker handle
The epoxy floor paint finish construction
In epoxy floor paint finish construction of this ring, you can roll coating according to the actual needs of customers use, brushing, coating, etc. for construction eels, in order to achieve different effects. Underground parking entrance slope was relatively large, and therefore a high slip resistance requirements on the ground. Stop underground garage floor construction landslide genuine difficult, mainly comprises seven steps, concrete construction method is as follows:
1, clean up, clean the base surface
Wash with water cannons ground, clear the ground of oil and other impurities, if potholes, holes, also handle.
2, primer construction
Overall spray penetration primer material into the concrete and closing the pores of the concrete floor solid integration.
3, compressive layer construction
After the primer dried, Scraping slip compressive layer, in the vast majority of ramp-slip floor project, compressive layer is yellow slip compressive material, this layer will be partial nudity, As part of the ramp line.
4, marking and paste Masking
On the ground mark the auxiliary grid lines, planned无论对于水泥地面或是瓷砖地面,我们必须进行打磨,而对于瓷砖地面必须进行深度打磨,因瓷砖地面材质本身相对致密,不容易渗透和粘接,只有把地面打磨精糙,才能增强地坪漆与地面的粘接效果。而相对于对于地面要求平整度高,以须耐磨的地面,必须解决瓷砖间隔的缝隙。这一关相对耗时,但又是非常重要的一环。
2.环氧树脂地坪漆底涂施工
因环氧树脂地坪漆底漆在地坪漆的涂层中起到承上启下的作用,施工必须足量,均匀,以增强环氧树脂耐磨地坪底漆的强度以及耐磨性,以避免起壳,脱层等现象的发生。
3.环氧树脂地坪漆砂浆层必须进行加厚处理
4.环氧地坪漆面漆施工
在环氧树脂地坪漆面漆施工这一环,可以根据客户的实际需求采用辊涂,刷涂,馒涂等方式进行施工,以达到不同的效果。地下停车场出入口坡度都比较大,因此对地面的防滑性要求很高。地下车库止滑坡道地坪施工难度比较大,主要包含7个步骤,具体施工方法如下:
1、清理、清洁基面
用高压水枪清洗地面,**地面油污和其它杂质,如果有坑洼、孔洞等也要处理好。
2、底涂施工
整体喷洒渗透底涂材料,渗入混凝土并封闭毛孔,使混凝土地面牢固整合。
3、抗压层施工
待底涂干燥后,批刮止滑抗压层,在绝大多数的坡道止滑地坪工程中,抗压层用的都是黄色止滑抗压材料,这一层将会部分裸露,作为坡道线部分。
4、划线并贴美纹纸
在地面上划好辅助网格线,规划好
资讯来源:<联系电话:400-0709-910>
|