无锡体育场馆地坪价格是多少 400-0709-910(请拨打400-0709-910电话,永坚地坪公司)
久性硬化基面,提高硬度、强度。化学反应形成坚实不能溶解的石胶化合物,可**性不被水溶解。硬化效果快而显著,正常基面施工干抛后即可达到类似大理石的硬度,环氧钢刀角都不易划伤,30-60天后达**效果,为一般同类产品不能相比。能深层(3-5mm)渗入的特性,可提高基面的整体强度。
2) **性耐磨、防尘。通过化学反应,可防止碱化和风化,从而**性耐磨、防尘。
3) **性密封、抗渗,化学反应形成坚实不能溶解的石胶化合物,封锁了基面的毛细孔,从而**性密封、抗渗。滴水测试会有成珠感,即有抗渗、自洁效果(30-60天后效果更好),可抗油污及其它化学物质。
4) **性耐压、不脱层。材料与基面发生整体化学反应后,形成一个不可分离的整体,不是在基础表面成膜,并可保持基面的呼吸功能,所以不怕潮气、不会脱层。
应用范围:
金刚砂地面无尘光亮处理用于室内外金刚砂耐磨地坪、水磨石地坪、原浆收光地坪、超平地坪、水泥自流平地坪、普通水泥地坪、石材等基面上,适应于工厂车间、仓库、商场超市、码头、路面混凝土表层脱皮原因分析:道路混凝土因其水泥胶材用量普遍较大、坍落度较小,混凝土内部水份的泌出速度较慢,泌出水量较小;过早进行压光收面工作,会造成混凝土表层提早失水硬化,而内部混凝土尚处于松软塑性状态;同时,混凝土内部水份泌出排放速度较慢,在混凝土表层密实硬化后,内部泌出排放的水份只能集聚在表层以下,使表层与内部混凝土之间形成界面分离层;在水份集聚充足时将会顶破密实硬化的薄皮表层排出水份,使内外混凝土因分离层处的水份排出造成脱皮。
2.路面混凝土表层起粉原因分析:表层灰浆因压光收面力度不足,减小与下层混凝土的粘合力;泌出灰浆在风吹日晒等因素不良影响下过早失水而硬化;这种非正常的失Long sclerosis base, improve the hardness, strength. Stone plastic chemical reaction to form a solid compound insoluble, can not be dissolved permanent water. Fast and significant hardening effect, normal base can achieve a similar hardness marble polishing dry after construction, epoxy steel angles are difficult to scratch, 30-60 days after the best results can not be compared to similar products in general. To deep characteristics (3-5mm) penetration can enhance the overall strength of the base surface.
2) Permanent wear and dust. Through a chemical reaction that prevents alkaline and weathering, permanently wear and dust.
3) permanently sealed, impervious, chemical reaction to form insoluble solid stone glue compound, blocked the pores of the base surface, permanently sealed and impervious. Beads dripping test will feel that there is impermeability, self-cleaning effect (30-60 days better), resistant to oil and other chemicals.
4) Permanent pressure, no delamination. After the material and the base surface overall chemical reaction occurs to form a inseparable whole, not on the basis of the surface of a film, and keep breathing function of the base surface, so afraid of moisture, will not delaminate.
Applications:
Emery ground handling clean bright for indoor and outdoor carborundum wearable Floor, terrazzo floors, floor puree received light, ultra-flat floor, self-leveling cement floor, ordinary cement floor, stone and other base surface, adapted to the plant workshops, warehouses, supermarkets, docks, concrete pavement surface peeling Cause Analysis: Road concrete cement material because of its large amount of general slump less secretion of moisture inside the concrete slower, less bleeding out of water ; premature calendered surface work income, will cause early loss hardening concrete surface, and the concrete is still in the soft plastic state; at the same time, inside the concrete water discharge slower secretion in hardened concrete surface compacting, internal bleeding the discharge of water can accumulate in the surface below the separation layer forming the interface between the surface and the interior concrete; when adequate moisture will gather thin dense surface hardening bursting discharge water, the inner and outer concrete due to the separation layer water discharge cause peeling.
2. Analysis of concrete pavement surface from the powder reasons: because the surface mortar surface calender income is insufficient, the adhesive force is reduced with the underlying concrete; secretion mortar in the sun and wind under the influence of adverse factors such as dehydration and premature hardening; This abnormal loss
资讯来源:<联系电话:400-0709-910>
|